Pilih Bahasa:
STET Triboelectrostatic separation has been used for the commercial beneficiation of coal combustion fly ash to produce a low carbon product for use as a cement replacement in concrete for nearly 20 years….
Muat turun PDFF. Hrach, S. Gasiorowski, H.Guicherd
Peralatan ST & Teknologi LLC (STET), 101 Hampton Avenue, Needham MA 02494 AMERIKA SYARIKAT
CONFERENCE: Vietbuild Ho Chi Minh City – Jun 2015
KATA KUNCI: Triboelectrostatic, Beneficiation, Dry Fly Ash, Carbon Separation ABSTRACT
STET Triboelectrostatic separation has been used for the commercial beneficiation of coal combustion fly ash to produce a low carbon product for use as a cement replacement in concrete for nearly twenty years. With 18 separators in 12 coal-fired power plants across the world, Peralatan ST & Teknologi LLC (STET) patented electrostatic separator has been used to produce over 15 Million tonnes of low carbon product.
To date, commercial beneficiation of fly ash has been performed exclusively on dry “run of station” ash. STET’s electrostatic beneficiation technology reduces the carbon content of coal fly ash, producing consistent, low carbon ash for use as a substitute for cement. Fly ash with carbon levels up to 25% have been used to produce ash with a controlled carbon level of 2 ± 0.5%. A carbon-rich product is simultaneously produced to recover the fuel value of the carbon.
Pengenalan
The American Coal Ash Association (ACAA) annual survey of production and use of coal fly ash reports that between 1966 Dan 2011, over 2.3 billion short tons of fly ash have been produced by coal-fired utility boilers.1 Of this amount, Kira 625 million tons have been beneficially used, mostly for cement and concrete production. Walau bagaimanapun, the remaining 1.7+ billion tons are primarily found in landfills or filled ponded impoundments. While utilization rates for freshly generated fly ash have increased considerably over recent years, with current rates near 45%, Kira 40 million tons of fly ash continues to be disposed of annually. While utilization rates in Europe have been much higher than in the US, considerable volumes of fly ash have also been stored in landfills and impoundments in some European countries. An excessive amount of unburned carbon in fly ash is the most common problem. The American Association of State Highway and Transportation Officials (AASHTO) and European Standards (EN 450 Category A) require that the amount of unburned carbon in fly ash, measured by loss on ignition (LOI) not exceed 5% by weight. Walau bagaimanapun, starting in the mid-1990s, installation of mandated NOx control equipment at coal-fired power plants increased the carbon (LOI) content of much of the previously marketable fly ash. Further requirements to reduce NOx and other power plant emissions have resulted in the contamination of fly ash with ammonia. As a consequence, while understanding the benefits of using fly ash in concrete continues to increase, the availability of suitable quality fly ash is decreasing. Processes to economically beneficiate off-quality fly ash are thus also of increasing interest to the power and concrete industries. STET has pioneered such processes for both carbon and ammonia removal from fly ash.
TECHNOLOGY OVERVIEW – FLY ASH CARBON SEPARATION
In the STET carbon separator (Rajah 1), the material is fed into the thin gap between two parallel planar electrodes. The particles are triboelectrically charged by interparticle
contact. The positively charged carbon and the negatively charged mineral (in freshly generated ash that has not been wetted and dried) are attracted to opposite electrodes. The particles are then swept up by a continuous moving belt and conveyed in opposite directions. Tali pinggang menggerakkan zarah bersebelahan setiap elektrod ke arah hujung bertentangan pemisah. Kelajuan tali pinggang yang tinggi juga membolehkan kendandahan yang sangat tinggi, selewat-lewatnya 36 tonnes per hour on a single separator. Jurang kecil, high voltage field, countercurrent flow, vigorous particle-particle agitation and self-cleaning action of the belt on the electrodes are the critical features of the STET separator. Dengan mengawal pelbagai parameter proses, seperti kelajuan tali pinggang, the feed point, dan kadar suapan, proses STET menghasilkan abu terbang LOI rendah pada kandungan karbon kurang daripada 1.5 untuk 4.5% from feed fly ashes ranging in LOI from 4% kepada lebih 25%.
Fig. 1 STET Separator
The separator design is relatively simple and compact. Mesin yang direka untuk memproses 36 tonnes per hour is approximately 9 m (30 Ka.) panjang, 1.5 m (5 Ka.) Luas, Dan 2.75 m (9 Ka.) Tinggi. Tali pinggang dan penggelek yang berkaitan adalah satu-satunya bahagian yang bergerak. Elektrod-elektrod adalah alat tulis dan terdiri daripada bahan tahan lama yang sesuai. The belt is made of nonconductive plastic. The separator’s power consumption is about 1 kilowatt-hour per tonne of material processed with most of the power consumed by two motors driving the belt.
Proses ini sama sekali Kering, requires no additional materials other than the fly ash and produces no wastewater or air emissions. Bahan-bahan yang pulih terdiri daripada Abu Terbang mengurangkan kandungan karbon kepada tahap yang sesuai untuk digunakan sebagai satu Tambah pozzolanic dalam konkrit, and a high carbon fraction useful as fuel. Penggunaan kedua-dua aliran produk menyediakan 100% penyelesaian kepada masalah penjualan Abu Terbang.
RECOVERED FUEL VALUE OF HIGH-CARBON FLY ASH
In addition to the low carbon product for use in concrete, brand named ProAsh®, the STET separation process also recovers otherwise wasted unburned carbon in the form of carbon-rich fly ash, branded EcoTherm™. EcoTherm™ has significant fuel value and can easily be returned to the electric power plant using the STET EcoTherm™ Return system to reduce the coal use at the plant. When EcoTherm™ is burned in the utility boiler, the energy from combustion is converted to high pressure /high-temperature steam and then to electricity at the same efficiency as coal, typically 35%. The conversion of the recovered thermal energy to electricity in ST Equipment & Technology LLC EcoTherm™ Return system is two to three times higher than that of the competitive technology where the energy is recovered as low-grade heat in the form of hot water which is circulated to the boiler feed water system. EcoTherm™ is also used as a source of silica and alumina in cement kilns, displacing the more expensive raw materials, such as shale or bauxite, which are used in cement production. Utilizing the high carbon EcoTherm™ ash either at a power plant or a cement kiln, maximizes the energy recovery from the delivered coal, reducing the need to mine and transport additional fuel to the facilities.
STET’s Talen Energy Brandon Shores, SMEPA R.D. Morrow, NBP Belledune, RWEnpower Didcot, EDF Energy West Burton, and RWEnpower Aberthaw fly ash plants, all include EcoTherm™ Return systems. The essential components of the system are presented in Figure 2.
Fig. 2 EcoTherm™ Return system
STET ASH PROCESSING FACILITIES
Controlled low LOI fly ash is produced with STET’s technology at twelve power stations throughout the U.S., Kanada, the U.K., Poland, dan Republik Korea. ProAsh® fly ash
has been approved for use by over twenty state highway authorities, juga kerana banyak agensi spesifikasi. ProAsh® juga telah disahkan di bawah Persatuan piawaian Kanada dan EN 450:2005 standard kualiti di Eropah. Ash kemudahan pemprosesan menggunakan teknologi STET disenaraikan dalam Jadual 1.
Jadual 1. STET Commercial Operations
| Utiliti / Stesen Janakuasa | Lokasi | Bermulanya Komersil operasi | Butir-butir Kemudahan |
|---|---|---|---|
| Duke Energy – Roxboro Stesen | North Carolina AMERIKA SYARIKAT | Sept. 1997 | 2 Pemisah |
| Talen tenaga - Brandon Shores Station | Maryland AMERIKA SYARIKAT | April 1999 | 2 Pemisah 35,000 ton storage dome. Ecotherm™ Return 2008 |
| ScotAsh (Lafarge / Scottish Power Joint Venture) - Stesen Longannet | Scotland Uk | Oct. 2002 | 1 Pemisah |
| Jacksonville Electric Authority - St. John’s River Power Park, FL | Florida AMERIKA SYARIKAT | Mungkin 2003 | 2 Pemisah Coal/Petcoke blends Ammonia Removal |
| South Mississippi Electric Power Authority R.D. Morrow Stesen | Mississippi AMERIKA SYARIKAT | Jan. 2005 | 1 Pemisah Ecotherm™ Return |
| New Brunswick Power Company Belledune Station | New Brunswick, Kanada | April 2005 | 1 Pemisah Coal/Petcoke Blends Ecotherm™ Return |
| RWE npower Didcot Station | England Uk | Ogos 2005 | 1 Pemisah Ecotherm™ Return |
| Talen Energy Brunner Island Stesen | Pennsylvania AMERIKA SYARIKAT | Disember 2006 | 2 Pemisah 40,000 Ton storage dome |
| Tampa Electric Co. Big Bend Station | Florida AMERIKA SYARIKAT | April 2008 | 3 Pemisah, pas berganda 25,000 Ton storage dome Ammonia Removal |
| RWE npower Aberthaw Station (Lafarge Cement UK) | Wales Uk | September 2008 | 1 Pemisah Ammonia Removal Ecotherm™ Return |
| EDF Energy West Burton Stesen (Lafarge Cement UK, Cemex) | England Uk | Oktober 2008 | 1 Pemisah Ecotherm™ Return |
| ZGP (Lafarge Simen Poland / Ciech Janikosoda JV) | Poland | Mac 2010 | 1 Pemisah |
| Korea South-East Power Yeongheung Units 5&6 | Korea Selatan | September 2014 | 1 Pemisah Ecotherm™ Return |
| Lafarge Simen Poland Warsaw | Poland | 2016 | 1 Pemisah |
CONCLUSIONS
Maximizing the utilization of fly ash as a cement substitute in concrete production substantially reduces the carbon dioxide emissions associated with construction activity. Walau bagaimanapun, pollution control systems implemented by the coal-fired power stations have resulted in a reduction of available fly ash meeting concrete-grade specifications. Further degradation of fly ash quality is expected due to further reductions in allowable gas emissions. In order to avoid loss of this valuable resource of material for concrete production as well as reduction of greenhouse gas emissions associated with concrete construction, processes for restoring the quality of the fly ash in an economic and environmentally viable way are needed.
The beneficiation of fly ash with STET processes further increases the supply of this important material. The STET beneficiation processes continue to be the most extensively applied methods to upgrade otherwise unusable fly ash to high-value materials for cement replacement in concrete. Eighteen SETT carbon separators are currently in place with over 100 machine-years of operation.
ProAsh® has found wide acceptance in the concrete industry as a premium fly ash requiring far less monitoring of air entrainment requirements due to less LOI variability than other ashes. Returning the high-carbon concentrate from the STET process to the boiler at a power plant allows recovery of the recovered carbon fuel value at an efficiency similar to coal. STET offers economical means to recover ash for high-value use that would otherwise be landfilled. Electrostatic carbon separation and Ecotherm™ return to the boiler provide a modular solution to a utility’s fly ash needs. These processes can be implemented in phases, or as a single project.
Rujukan
[1] American Coal Ash Coal Combustion products and Use Statistics:
https://www.acaa-usa.org/Publications/Production-Use-Reports/
