Bauxite Beneficiation Electrostatic

The most widely used chemical process of refining bauxite into alumina, the Bayer process, involves dissolving the Al2O3 out of the bauxite rock with caustic soda (سود) at elevated temperature and pressure. The Al2O3 fraction of the bauxite is dissolved into solution, to later be precipitated out as alumina. با این حال, a high-grade bauxite contains up to 60% Al2O3 به, and many operating bauxite deposits are well below this, occasionally as low as 30-40% Al2O3 به. Because the desired product is a high purity Al2O3, the remaining oxides in the bauxite (Fe2O3, به SiO2, TiO2, Organic material) are separated from the Al2O3 and rejected as alumina refinery resides (ARR) or red mud. به طور کلی, the lower quality the bauxite (ie lower Al2O3 content) the more red mud is generated per ton of alumina product. علاوه بر این, even some Al2O3 bearing minerals, notably kaolinite, produce un-desirable side reactions during the refining process and lead to an increase in red mud generation, as well as a loss of expensive caustic soda chemical, a large variable cost in the bauxite refining process.

Red mud or ARR represents a large and on-going challenge for the aluminum industry. Red mud contains significant residual caustic chemical leftover from the refining process, and is highly alkaline, often with a pH of 10 - 13. It is generated in large volumes worldwide – according to the USGS, estimated global alumina production was 121 million tons in 2016. This likely resulted in more than 150 million tons of red mud generated during the same period. Despite ongoing research, red mud currently has few commercially viable paths to beneficial re-use. It is estimated that very little of red mud is beneficially re-used worldwide. Instead the red mud is pumped from the alumina refinery into storage impoundments or landfills, where it is stored and monitored at large cost.

از دست دادن سودای گران قیمت سوستیک (سود) and the generation of red mud are both related to the quality of the bauxite used in the refining process. به طور کلی, the lower the Al2O3 content of the bauxite, هر چه حجم گل قرمز بزرگتر باشد که تولید خواهد شد, as the non-Al2O3 phases are rejected as red mud. علاوه بر این, the higher the kaolinite or reactive silica content of the bauxite, هر چه گل قرمز بیشتری تولید شود. The reactive silica content not only increases the volume of red mud, but also consumes caustic soda reagent and reduces the yield of Al2O3 recovered from the bauxite. از این رو, there is both an economic and environmental argument to be made for improving the quality of bauxite prior to refining.

فرایند جداسازی خشک STET ارائه می دهد تولید کنندگان بوکسیت و یا تصفیه کننده بوکسیت فرصتی برای انجام قبل از بایر فرایند ارتقاء سنگ بوکسیت برای بهبود کیفیت. این رویکرد مزایای زیادی دارد:

• کاهش هزینه عملیاتی پالایشگاه به دلیل مصرف کمتر سودای سوستیک با کاهش سیلیکای واکنش پذیر ورودی.
• Savings in energy during refining due to lower volume of inert oxides (Fe2O3, TiO2, Non-reactive SiO2) ورود با بوکسیت. Smaller mass flow of bauxite to refinery results in less energy to heat and pressurize.
• Reduction in red mud generation volume (ie – نسبت گل قرمز به آلومینا) by removing reactive silica and inert oxides.
• Tighter control over input bauxite quality to refinery reduces process upsets and allows refiners to target ideal reactive silica level to maximize impurity rejection.
• Improved quality control over bauxite feed to refinery reduces process upsets, maximizes uptime and productivity.
• Reduction in red mud volume translates into less treatment and disposal costs and better utilization of existing landfills.
• Unlike red mud, tailings from a dry electrostatic process contain no chemicals and do not represent a long-term environmental storage liability.
• Unlike red mud, dry by-products/tailings from a bauxite processing operation can be utilized in cement manufacture as there is no requirement to remove the sodium, which is detrimental to cement manufacture. در حقیقت – Bauxite is already a common raw material for Portland cement manufacturing.
• Extend operating life of existing bauxite mine by improving quarry utilization and maximizing recovery.
• STET is a low operating cost, high throughput continuous process. No water or chemicals required.